Longview, Washington

Kitchen Remodeling in Longview, WA

A lot of Longview was built in the 1920s through the 1950s, and almost none of those kitchens are square, plumb or level anymore. New cabinets are perfectly square boxes. Making the two agree is most of what separates a kitchen that looks right from one that never quite does.

Call (360) 431-9382 or book online for a free estimate.

Floors in older Longview houses usually slope somewhere, often toward the middle of the house where the house has settled. Cabinets set to the floor will follow that slope, and a countertop on top of them will too. The base cabinets get set to a level line and shimmed up to it, and the toe kick gets scribed to the floor so it reads clean. The uppers get hung to their own level line, not to a ceiling that may be off by an inch across the room.

Walls are the same story. Where a cabinet or a counter meets a wall that bows or leans, the gap gets taken up with a scribed filler or a scribed end panel, not a fat bead of caulk. That is slow, careful work, and it is the part you notice every day after the job is done.

Behind the old cabinets you tend to find what the house has been living with: galvanized water lines, old wiring and maybe one circuit for the whole counter. A modern kitchen needs dedicated circuits for the dishwasher, the disposal, the microwave and the counter outlets. That gets planned with the electrician up front, while the walls are open, so it is in the number instead of a surprise halfway through.

I have been doing this thirty years and I am on the job every day. Electrical and plumbing go to licensed trades. The cabinets, the trim and the running of the job are mine, and the kitchen is priced to the cabinets and counters you actually pick, not an allowance.

Save yourself the wait

Send me photos of the kitchen and rough dimensions, and tell me what you want changed. My office is on 9th Ave, so coming by to measure and look at the floor is easy.

Send photos and get a sketch

Kitchen Remodeling We Have Built

See all kitchen and bath photos

Kitchen Remodeling questions in Longview

My kitchen floor is not level. Is that a problem for new cabinets?

No, it is normal in older Longview houses. Base cabinets get set to a level line and shimmed, the toe kick gets scribed to the floor, and the counter ends up flat even if the floor is not. If the floor is soft or sagging rather than just out of level, that gets fixed first.

Will my old wiring handle a new kitchen?

Often not as it is. A modern kitchen wants several dedicated circuits. A licensed electrician looks at the panel and the runs before the layout is final, so the cost is in the number from the start.

Can you keep my layout and just replace cabinets and counters?

Yes. That is the fastest and least expensive kitchen to do, and in a lot of Longview houses the layout is fine. It still gets the same leveling and scribing so the new cabinets sit straight.

Can you open up the wall between the kitchen and dining room?

Usually. Whether it is bearing gets figured out before demo. If it is, a header and posts carry the load.

Do I need a permit for a kitchen remodel in Longview?

Swapping cabinets and counters in the same spots usually does not need a building permit. Moving a wall, adding circuits or moving plumbing does. I pull whatever the City of Longview requires, and the electrical and plumbing permits go with the licensed trades doing that work.

Are you a local kitchen remodeler in Longview?

James Hurula Construction is at 1801 9th Ave in Longview. Licensed, bonded and insured, owner on the job every day.

Kitchen Remodeling in Longview and Cowlitz County

James Hurula Construction is a licensed Washington general contractor (JAMESHC764LM) based here in town, serving Longview and Cowlitz County on every kind of job on this page. I also work in Kelso, Castle Rock, Kalama, Woodland, Cathlamet, Vancouver, Battle Ground, Ridgefield. Thirty years of field experience, owner on site.

View completed projects | Read customer reviews | Contact us

Ready to start your Longview project?

Call for a free same-day estimate. No pressure, no obligation. (360) 431-9382.