Gary Swanson Project

driveway replacement in Longview, WA

James Hurula Construction handled a comprehensive concrete replacement project covering the back patio, front driveway sections, and surrounding sidewalk areas. The existing concrete surfaces had reached the end of their useful life, and each area was restored with fresh, properly reinforced slabs built to last. The team brought care and craftsmanship to every phase of the job.

Scope of Work

James Hurula Construction, WA# JAMESHC764LM, will remove and replace the existing concrete at the back patio, front driveway sections, and sidewalk areas described in this estimate. Work will begin with demolition of the existing concrete surfaces at all listed locations, loading and hauling off the demolished material, and preparing the exposed areas for replacement. The work area will be dug down to remove approximately 2 inches of existing base material, and any tree roots encountered within the concrete replacement areas will be removed as part of the preparation.

After demolition and excavation are complete, new 5/8 inch minus gravel will be imported, placed, and compacted to grade across the prepared areas. Forms will be set to define the replacement concrete areas and maintain the required slab layout. Reinforcement will be installed using 3/8 inch rebar laid out on an approximate 2 foot grid before concrete placement.

Concrete will be placed in three separate pours as planned for the project. Pour 1 will include the back patio and includes use of a concrete pump for placement. Pour 2 and Pour 3 will include the driveway and sidewalk areas, assuming ready-mix truck access allows direct chute discharge as noted in the contingency. All new concrete will be placed at approximately 4 inches thick.

The front driveway and sidewalk surfaces will receive a heavy broom finish, and the back patio will receive a light broom finish. All finished concrete surfaces will be cured and sealed after placement to support proper curing and surface protection.

Upon completion, forms and job-related debris will be removed from the work areas, and the site will be left in a clean, workmanlike condition. Final project close-out will include review of the completed replacement areas and confirmation that the scope described in this estimate has been completed.

Project Gallery

James Hurula Construction left the property looking clean with the finished surfaces built right, delivering durable, well-finished concrete across all three areas.

About the contractor

James Hurula Construction is a licensed Washington general contractor (JAMESHC764LM) based in Longview, serving Kelso, Castle Rock, Kalama, Woodland, Cathlamet, Vancouver, Battle Ground and Ridgefield. Thirty years of field experience, owner on site. Electrical and plumbing go to licensed trades. The carpentry is mine.

Phone: (360) 431-9382. Address: 1801 9th Ave, Longview, WA 98632. Free project sketch.